Modul MPU-9250 GY-9250 ini memiliki multi chip sehingga dapat berfungsi untuk accelerometer, gyroscope, dan magnetometer

Auxiliary master I2C bus for reading data from external sensors (e.g. pressure sensor)
3.5mA operating current when all 9 motion sensing axes and the DMP are enabled
VDD supply voltage range of 2.4 – 3.6V
VDDIO reference voltage for auxiliary I2C devices
Smallest and thinnest QFN package for portable devices: 3x3x1mm
Minimal cross-axis sensitivity between the accelerometer, gyroscope and magnetometer axes
512 byte FIFO buffer enables the applications processor to read the data in bursts
Digital-output temperature sensor User-programmable digital filters for gyroscope, accelerometer, and temp sensor
10,000 g shock tolerant
400kHz Fast Mode I2C for communicating with all registers
1MHz SPI serial interface for communicating with all registers

Gyroscope Features :

Digital-output X-, Y-, and Z-Axis angular rate sensors (gyroscopes) with a user-programmable full scale range of ±250, ±500, ±1000, and ±2000°/sec and integrated 16-bit ADCs
Digitally-programmable low-pass filter
Gyroscope operating current: 3.2mA
Sleep mode current: 8µA
Factory calibrated sensitivity scale factor
Self-test

Accelerometer Features :

Digital-output triple-axis accelerometer with a programmable full scale range of ±2g, ±4g, ±8g and±16g and integrated 16-bit ADCs
Accelerometer normal operating current: 450µA
Low power accelerometer mode current: 8.4µA at 0.98Hz, 19.8µA at 31.25Hz
Sleep mode current: 8µA
User-programmable interrupts
Wake-on-motion interrupt for low power operation of applications processor
Self-test

Magnetometer Features

3-axis silicon monolithic Hall-effect magnetic sensor with magnetic concentrator
Wide dynamic measurement range and high resolution with lower current consumption
Output data resolution of 14 bit (0.6µT/LSB)
Full scale measurement range is ±4800µT
Magnetometer normal operating current: 280µA at 8Hz repetition rate
Self-test function with internal magnetic source to confirm magnetic sensor operation on end products