Chip mikrokontroler ATtiny2313 ini memiliki form factor DIP 20 pin sehingga mudah diaplikasikan pada pcb atau breadboard.

• Utilizes the AVR® RISC Architecture
• AVR – High-performance and Low-power RISC Architecture
• 120 Powerful Instructions – Most Single Clock Cycle Execution
• 32 x 8 General Purpose Working Registers
• Fully Static Operation
• Up to 20 MIPS Throughput at 20 MHz
• Data and Non-volatile Program and Data Memories
• 2K Bytes of In-System Self Programmable Flash
Endurance 10,000 Write/Erase Cycles
• 128 Bytes In-System Programmable EEPROM
Endurance: 100,000 Write/Erase Cycles
• 128 Bytes Internal SRAM
• Programming Lock for Flash Program and EEPROM Data Security
• One 8-bit Timer/Counter with Separate Prescaler and Compare Mode
• One 16-bit Timer/Counter with Separate Prescaler, Compare and Capture Modes
• Four PWM Channels
• On-chip Analog Comparator
• Programmable Watchdog Timer with On-chip Oscillator
• USI – Universal Serial Interface
• Full Duplex USART
• debugWIRE On-chip Debugging
• In-System Programmable via SPI Port
• External and Internal Interrupt Sources
• Low-power Idle, Power-down, and Standby Modes
• Enhanced Power-on Reset Circuit
• Programmable Brown-out Detection Circuit
• Internal Calibrated Oscillator
• 18 Programmable I/O Lines
• 20-pin PDIP, 20-pin SOIC, 20-pad QFN/MLF
• 2.7 – 5.5V (ATtiny2313)
• Speed grades: 0 – 10 MHz @ 2.7 - 5.5V, 0 – 20 MHz @ 4.5 – 5.5V
• Typical Power Consumption :– Active Mode 1 MHz, 1.8V: 230 µA
32 kHz, 1.8V: 20 µA (including oscillator)– Power-down Mode < 0.1 µA at 1.8V